| |
TM 10-3930-664-24
2. BLEED SERVICE BRAKES
a.
Locate bleeder screws (5). Screws are located
on top of differential housing, one on each side
of housing.
CAUTION
To
prevent
damage
to
master
cylinder, do not apply more than 30
psi (206 kPa) to pressure bleeder.
b.
Remove filler cap (6) from master cylinder (7)
for rear brake system. Install pressure bleeder
onto master cylinder using appropriate adapter
from pressure bleeder set.
c.
Using pressure bleeder, apply pressure and
open bleeder screws (5) to allow air to escape.
d.
Close bleeder screws (5) once system is bled.
Disconnect pressure bleeder.
3. CHECK MASTER CYLINDER AND SERVICE AS
REQUIRED (PARA. 2-110).
2-289
|
