TM 10-3930-664-24 6.     REMOVE   DRAIN   LINE   (31)   FROM   FOUR   FUEL INJECTORS        (33)        BY        REMOVING    BANJO CONNECTOR   SCREWS   (34)   AND   SEALS   (35). DISCARD SEALS. 7.     REMOVE  INJECTION  PUMP  SUPPLY  LINES  (12, 36, 40). a. Disconnect  injection  pump  supply  line  (36)  from rear fitting on injection pump (37). b. Disconnect    supply    line    (36)    from    tee    (38). Remove and discard grommet seal (39). c. Disconnect  supply  line  (40)  from  front  fitting  on injection pump (37). d. Disconnect    supply    line    (40)    from    tee    (38). Remove and discard grommet seal (39). e. Disconnect    supply    line    (12)    from    tee    (38). Remove and discard grommet seal (39). B.  CLEANING Clean fuel lines and fittings in accordance with paragraph 1-24. C.  INSPECTION Inspect   components   in  accordance   with paragraph 1-24. 2-100