TM 10-3930-664-24 1.     DISCONNECT   HOSE   ASSEMBLIES   (1,   2)    AND REMOVE  TEES  (3),  ADAPTER  (4),  AND  ELBOW (6).  DISCARD O-RINGS. a. Tag and disconnect hose assemblies (1, 2) from tees (3) and elbow (6). b. Remove  pipe  plug  (4)  and  fitting  (5)  from  upper tee (3). c. Remove pressure sensor adapter (7) and elbow (6) from lower tee (3). d. Remove  tees  (3)  from  banjo  connector  screws (8).  Remove and discard O-rings (9). 2.     REMOVE   LOW   PRESSURE   AND   FUEL   SUPPLY LINES (10, 12). a. Disconnect  low  pressure  fuel  line  (10)  from  fuel lift transfer pump (14) by loosening line nut. b. Disconnect    low    pressure    fuel    line    (10)    from engine   by   removing   banjo connector screw (8)  and  sealing  washers  (11).    Discard  sealing washers. c. Disconnect  fuel  supply  line  (12)  from  engine  by removing banjo connector screw (8) and sealing washers (13).  Discard sealing washers. 3.     DISCONNECT    FOUR    HIGH    PRESSURE    FUEL LINES   (15)   FROM   FUEL   INJECTORS   (16)   AND INJECTION PUMP. 2-98