TM10-3930-660-34 16-16.   BOOM EXTEND CYLINDER - REPLACE/REPAIR (Cont’d) h. Remove hoist and sling from back of extend cylinder. i. Install eight hex head capscrews (15) and eight locknuts (16) to secure extend cylinder anchor (17). NOTE Attach a hoist with sling at front of inner boom if mounting holes between outer boom and extend cylinder anchor do not align.  Move inner boom as needed to align mounting holes. j. Remove wood blocks underneath boom extend cylinder and inner boom. NOTE When installing capscrews (9), apply Loctite #242 on threads. 2. CONNECT HOSES (4) AND INSTALL COVER (3). a. Connect two hoses (4) to extend cylinder. b. Install pulley (13) with bracket (12). c. Remove two hex head capscrews (9) two flatwashers (11) and two new lockwashers (10) that held boom wear pad (14) in place. d. Apply Loctite #242 on threads of capscrews (9) and re-install them and flatwashers (11) to secure bracket (12). e. Adjust hose and cable tension, TM10-3930-660-20. f. Install cover (3), four new lockwashers (2) and four hex head capscrews (1). 16-106