16-10. CARRIAGE TILT CYLINDER - REPATR (Contd)
The nut (8) may need to be heated with a torch for
Remove nut (8) and washer (9). Discard nut (8).
Remove piston (10) and discard 0-ring
(11).Discard O-ring (11).
Remove washer (12) and slide gland (3) off rod
Remove O-ring (5) and back-up ring (13) from
gland (3).Discard O-ring (5).
Do not nick or scratch seal groove during removal of seal
(14) and rod wiper (15).Failure to follow this precaution
will cause part damage.
Note direction that lip of seal (14) is facing before
Remove seal (14) and rod wiper (15) from inside of
m. Remove bushing (16).
See Cleaning Instructions, para.2-10.
See Inspection Instructions, para.2-11.