TM10-3930-660-34 8-5. FRONT DIFFERENTIAL CARRIER ASSEMBLY - REPLACE/REPAIR/ADJUST (Cont’d) d.   Support assembly under ring gear (22) with metal or wood blocks and use a press to remove case half (26) through gear (22). Separate flange case half (26) and ring gear (22). 4. REMOVE BEVEL PINION (12) AND BEARING CAGE (28) FROM DIFFERENTIAL CARRIER (2). a.   Place differential carrier (2) on bench with bevel pinion (12) facing up.  Clamp carrier securely. b.   Remove eight capscrews (29) and pinion bearing cage cover (30). c.   Use a suitable puller to remove bevel pinion bearing oil seal (31). d.   Remove pinion bearing cage thrust washer (32). e.   Remove pinion bearing cage cover gasket (33).  Discard gasket (33). f. Remove bevel pinion (12) with bearing cage (28) and shims (34) from the differential carrier (2).Keep shims together for use during assembly.  If shims are damaged,  measure total thickness of shim pack and note dimension; discard shims (34). Shim thickness dimension will be needed to calculate depth of bevel pinion in differential carrier when gear set is installed. 8-14