TM10-3930-660-34 7-4. TRANSMISSION ASSEMBLY - REPLACB/REPAIR (Cont’d) h. Slide retainer (73) out of shaft assembly (67). CAUTION Carefully   handle   clutch   plates   (74)   so   graphite   coating doesn’t  flake  off.      Failure   to   follow   this   precaution   could cause equipment damage. i. Remove six clutch plates (74) and six separator plates (75). NOTE The second stage clutch pack contains twelve clutch plates (74) and twelve separator plates (75). j. Turn shaft assembly (67) over. k. Use two pry bars 1800 apart to pry bearing (76) up and remove it from shaft assembly (67). l. Remove snap ring (77). m. Use a gear puller to remove weld gear (78) and two bearings (79) as an assembly from shaft assembly (67). WARNING Springs (82) are under tension.  Always wear safety glasses when   working   on   compressed   springs.      Carefully   handle spring in compressed form.  Failure to follow this precaution could cause personal injury. 7-17