TM10-3930-660-34 7-4. TRANSMISSION ASSEMBLY - REPLACE/REPAIR (Cont’d) n. Turn shaft assembly over (50) and repeat STEPS b - m. 6. DISASSEMBLE SECOND STAGE CLUTCH PACK (47). CAUTION Use care when removing seal rings (66) to prevent clutch shaft damage. a. Remove three seal rings (66) from shaft assembly (67). b. Use two pry bars 1800 apart to pry bearing (68) up and remove it from shaft assembly (67). c. Remove snap ring (69) from shaft assembly (67). d. Use a gear puller to remove weld gear (70) and bearing (71) as an assembly from shaft assembly (67). e. Using an assistant to spread snap ring (72),  use a driver to remove bearing (71) from weld gear (70). f. Remove snap ring (120). g. If necessary remove snap ring (72) from weld gear (70). 7-16