TM 10-3930-660-34 3-19.1. PUSH ROD COVER - REPLACE This task covers: a. Removal b. Installation INITIAL SETUP Tools Materials/Parts Tool Kit, Automotive Mechanics Gasket (7) Grommet Seals (5) Shop Equipment, Automotive K & W Copper Coat 1504 (App. B, Item Maintenance, Common #2 14) Less Power Equipment Condition Fuel filter assembly removed, TM 10-3930-660-20. Fuel injection pump removed, para. 4-4. Note The push rod cover is accessed through the right-hand engine access door. REMOVAL 1. REMOVE SPRING CLAMP (1) FROM HOSE (2) AND REMOVE HOSE (2) FROM PUSH ROD COVER (3). 2. REMOVE SIX CAPSCREWS (4) WITH SIX GROMMET SEALS (5) WHICH SECURE PUSH ROD COVER (3) TO ENGINE BLOCK (6). DISCARD GROMMET SEALS (5). 3. REMOVE ROD COVER (3) AND PUSH ROD COVER GASKET (7) FROM ENGINE BLOCK (6). DISCARD GASKET (7). 4. IF NECESSARY, REMOVE BAFFLE (8) FROM PUSH ROD COVER (3). INSTALLATION 1. IF REMOVED, ALIGN BAFFLE (8) ON PUSH ROD COVER (3). NOTE Position adhesive side of gasket (7) towards cover (3) Apply K & W copper coat 1504 sealant to engine block side of gasket (7). 2. POSITION PUSH ROD COVER WITH NEW GASKET (7) IN PLACE ON ENGINE BLOCK (6). 3. SECURE PUSH ROD COVER (3) TO BLOCK (6)USING SIX CAPSCREWS (4) WITH SIX NEW GROMMET SEALS (5). TORQUE CAPSCREWS TO 216 IN. LB. 4. POSITION HOSE (2) ON FITTING AT PUSH ROD COVER (3). SECURE HOSE WITH SPRING CLAMP (1). 5. INSTALL FUEL INJECTION PUMP, PARA. 4-4. 6. INSTALL FUEL FILTER ASSEMBLY, TM 10-3930- 660-20. 3-122