12. ETHER START ATOMIZER REPLACE-
MENT (new engine)
AFTER INSTALLATION OF NEW ENGINE REMOVAL
a. Remove plug (1) from new engine block.
INSTALLATION (Figure 23)
Note: Install tie wraps as necessary.
a. Apply sealing compound to threads of (From the
kit) Bushing #8530024 (2) and install on new
Note: Punch mark on hex must be located on the bottom
side of atomizer when tight.
b. Apply sealing compound to threads of (from the
kit) atomizer #8277101 (3) and install into
bushing (2) on new engine block. Tighten to 25
c. Connect hose (4) to atomizer (3).