 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0312 00
CLEANING INSTRUCTIONS
WARNING
Solvent cleaning compound, MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition.
Improper cleaning methods and use of unauthorized cleaning solvents may injure personnel and damage
equipment. Refer to TM 9-247 for correct information.
Fire extinguishers should be placed nearby when using solvent cleaning compound.
Cloths or rags saturated with solvent cleaning compound must be disposed of IAW authorized facilities
procedures.
Eye shields must be worn when cleaning with a wire brush. Flying rust and metal particles may cause
injury to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may cause
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
1.
General.
a.
Cleaning instructions will be the same for the majority of parts and components that make up the forklifts.
b.
The importance of cleaning must be thoroughly understood by maintenance personnel. Great care and effort are
required in cleaning. Dirt and foreign material are a constant threat to satisfactory maintenance. The following
should apply to all cleaning, inspection, repair and assembly operations.
(1)
Clean all parts before inspection, after repair and before assembly.
(2)
Hands should be kept free of accumulation of grease, which can collect dust, dirt or grit.
(3)
After cleaning, all parts should be covered or wrapped to protect them from dust and dirt. Parts that are
subject to rust should be lightly oiled.
2.
External Engine Cleaning.
a.
Protect all electrical equipment that could be damaged by the steam or moisture before steam cleaning.
b.
Cover all openings before steam cleaning.
c.
After cleaning, dry and apply a light coat of oil (Item 30, WP 0323 00) to all parts subject to rust.
d.
Clear out all tapped (threaded) holes with compressed air to remove dirt and cleaning fluid.
3.
Cleaning Disassembled Parts.
a.
Place all disassembled parts in wire baskets for cleaning.
b.
Dry and cover all cleaned parts.
c.
Place parts on or in "racks" and hold for inspection or repair.
d.
All parts subject to rusting must be lightly oiled and wrapped.
e.
Keep all related parts and components together. Do not mix parts.
0312 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals