Quantcast DISASSEBMLY - CONTINUED -832450558

 

Click here to make tpub.com your Home Page

Page Title: DISASSEBMLY - CONTINUED
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
DISASSEBMLY - CONTINUED -832450557
Up
TM-10-3930-660-24-2 Truck Forklift; 6 000 lb. Variable Reach Rough Terrain Manual
Next
ASSEMBLY -832450559
TM 10-3930-660-24-2
FRONT DIFFERENTIAL CARRIER ASSEMBLY MAINTENANCE - CONTINUED
0296 00
DISASSEMBLY - CONTINUED
25.
Place bevel pinion (19) and bearing cage (20) in a
32
33
press with splined end at the top of assembly.
19
26.
Support bearing cage (20) under flange area with
metal or wood blocks.
28
30
27.
Use a press or leather mallet and driver to remove
bevel pinion (19) from bearing cage (20).
29
20
28.
Remove outer bearing (27) from bearing cage (20).
31
29.
Use puller to remove inner bearing cone (28) and
27
bearing spacer (29) from bevel pinion (19).
30.
Use puller to remove inner bearing cup (30) and outer
bearing cup (31) from bearing cage (20).
31.
Install a soft metal cover over vise jaws to protect
bevel pinion (19). Place bevel pinion (19) in a vise.
409-1242
32.
Use expanding snap ring pliers to remove snap ring
(32) from end of bevel pinion (19).
33.
Use a suitable puller to remove bearing (33) from spigot end of bevel pinion (19).
CLEANING
See Cleaning instructions (WP 0316 00).
INSPECTION
See Inspection instructions (WP 0317 00).
ASSEMBLY
NOTE
Pinion and ring gears are a matched set. If replacement of ring gear or pinion gear is necessary, replace both
gears as a set.
1.
Use a press or sleeve and driver to install inner bearing cup (30) and outer bearing cup (31) into bearing cage (28). Be
sure bearing cups are flat against bottom of cage bore.
2.
Use a press or sleeve and driver to install inner bearing cone (28) on bevel pinion (19).
3.
Use a press or sleeve and driver to install spigot bearing (33) onto spigot end of bevel pinion (19).
4.
Use expanding snap ring pliers to install snap ring (32) into groove in end of bevel pinion (19).
5.
Apply a thin film of clean lubricant to inner and outer bearing cups (30 and 31) and bearing cones (27 and 28).
6.
Install bevel pinion (19) into bearing cage.
7.
Install bearing spacer (32) on bevel pinion (19) against inner bearing cone (28).
8.
Use press or sleeve and driver to install outer bearing cone (37) on bevel pinion against bearing spacer (29).
0296 00-4

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.