TRANSMISSION INPUT SHAFT MAINTENANCE - CONTINUED
INSTALLATION - CONTINUED
Install transmission front cover assembly (1), torque converter (2) and front housing (3) as a unit to main case.
Position new gasket (9) on main case.
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Attach a hoist with sling, or other suitable lifting
device, to front cover assembly (1), torque converter
(2) and transmission front housing (3) as a unit. Lift
unit into position on main case.
Install four capscrews (8), three capscrews (7) and
capscrews (4 thru 6) which secure unit to main case.
Install transmission assembly (WP 0237 00).
Operate transmission, check for leaks and proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE