 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPAIR - CONTINUED
0289 00
DISASSEMBLY - CONTINUED
21
7
15,16
WARNING
17,18
Springs are under tension. Always wear
14
face shield when working on compressed
19
13
springs. Carefully handle spring in com-
20
pressed form. Failure to follow this pre-
22
caution could cause personal injury.
14.
Place shaft assembly (7) in a press. Install a clutch
spring compressor tool.
15.
Press down on spring compressor tool and retainer
(17) just enough to relieve pressure on retainer ring
(18). Remove retainer ring (18). Slowly remove clutch
spring compressor tool.
409-1157
16.
Remove retainer (17), four springs (19) and thrust
washer (20).
WARNING
Do not exceed 30 psi (207 kPa) nozzle pressure when using compressed air. Do not direct compressed air
against skin. Failure to follow this precaution could cause personal injury.
17.
Insert air nozzle at pressure ports (21) located between
three seal ring grooves on shaft assembly (7). Use
compressed air to remove piston (22).
24
18.
Remove and discard O-ring (23) and outer piston seal
(24).
19.
Turn shaft assembly (7) over and repeat steps 10 thru
23
20.
22
409-1158
0289 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals