Click here to make tpub.com your Home Page

Page Title: ASSEMBLY - CONTINUED
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-3930-660-24-2
ALTERNATOR ASSEMBLY MAINTENANCE (152 HP) - CONTINUED
0284 00
ASSEMBLY - CONTINUED
10.
Install collar (13) on rotor shaft and press rotor (7)
26 38
32
through ball bearing (14) and bore in drive end frame
25 30 29
(4) with a press.
33
19
11.
If removed, install pin (43) and bushing (42) to frame
27
(5).
8
28
20
12.
If removed, secure wire lead (26) to regulator (28)
20 31
with nut (38).
43
5
13.
If removed, install connector (37), relay terminal
assembly parts (36), and relay terminal cap (35).
34,35,36
37
17
14.
If removed, install battery terminal assembly parts
22 21
19
(34), connector (33) and nut (32).
16
15.
Place regulator (28), brush springs (31), and brush and
18
40 39 41
holder assembly (20) inside frame (5).
23
21
42
22
16.
Install screw (29), new lockwasher (30) and insulated
screw (19) to secure regulator (28), brush spring (31)
25
24
and brush and holder assembly (20) and frame (5).
17.
Install rubber cover (27) to terminals of regulator (28).
18.
Place rectifier bridge (23) inside frame (5).
24
25
NOTE
26
Holes for screw and lockwasher assem-
blies are located on the rectifier bridge,
closest to center of frame. One assembly
secures the upper contact of capacitor. The
23
other assembly secures wire lead.
21,22
5
19.
Secure wire lead (26) and top contact of capacitor (24)
to rectifier bridge (23) with two new screw and lock-
409-1098
washer assemblies (25).
NOTE
Holes for screws and springwashers are located on the rectifier bridge, closest to outside of frame. One of
the two screws secures the lower contact of capacitor.
20.
Secure rectifier bridge (23) to frame (5) with two screws (21) and two new spring washers (22).
21.
Secure diode trio (18) to brush and holder assembly (20) with insulated screw (19).
22.
Connect stator terminal clips (17) to diode trio (18) and rectifier bridge (23) with three nuts (16).
0284 00-7

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business