 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CAMSHAFT, GEAR AND BUSHING MAINTENANCE - CONTINUED
0278 00
INSTALLATION
NOTE
If a new camshaft is being installed, a new camshaft bushing must be installed.
1.
Mark location of oil hole (7) in camshaft bore using felt pen.
2.
Place camshaft bushing (5) in its bore, taking care to align oil hole in bushing with oil hole (7) in camshaft bore.
3.
Install camshaft bushing (5), using universal bushing installation tool, until bushing is flush with face of cylinder block.
4.
Check oil hole alignments by inserting a 0.128 in. (0.325 mm) diameter rod into bushing oil hole (8) and insuring that
rod can also enter oil hole (7) in camshaft bore. Remove and reinstall camshaft bushing (5) if oil hole alignment is unsat-
isfactory.
7
5
5
7,8
409-1024
409-1025
NOTE
The specified rod diameter represents the minimum sized oil passage required for adequate camshaft bush-
ing lubrication.
5.
Apply lubriplate to camshaft bores in cylinder block
and to lobes of camshaft.
2
6.
Position camshaft/gear/thrust plate in cylinder block.
1
7.
Align timing marks on camshaft gear with timing
mark on crankshaft gear.
8.
Install capscrews (1) in thrust plate (2) and tighten to 6
lb-ft (8 Nm).
9.
Install oil pan (WP 0219 00).
409-4115
10.
Install front housing cover (WP 0280 00).
11.
Install fuel transfer pump (WP 0022 00 or WP 0023 00).
12.
Install rocker arm levers (WP 0216 00).
13.
Install engine (WP 0209 00).
14.
Operate engine and check for proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE
0278 00-5/(-6 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals