CRANKSHAFT REAR SEAL REPLACEMENT - CONTINUED
INSTALLATION - CONTINUED
Tap alignment/installation tool at the 12, 3, 6 and 9 o'clock positions only. Striking the tool at other locations
could damage the seal carrier.
Place alignment/installation tool supplied with rear
seal kit onto crankshaft and against seal carrier with
the flange of the tool away from the seal.
Use a hammer to tap seal into seal retainer until flange
of tool is against seal retainer.
Install flywheel (WP 0214 00).
Run engine and check for leaks (TM 10-3930-660-10).
END OF WORK PACKAGE
0274 00-3/(-4 Blank)