TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
· If more than one hydraulic line is to be removed, identify lines to ensure proper installation. Use container to
catch any hydraulic oil that may drain from system.
· Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hydraulic components and hoses
clean and dry. Apply film of clean hydraulic oil to all seals as they are installed.
· Tag all electrical connections before removing for use during installation.
Raise boom to maximum height (TM 10-3930-660-
10). Use a hoist with sling or other device to support
Remove four capscrews (1), four lockwashers (2) and
disconnect front propeller shaft (3). Discard lockwash-
ers. Carefully lower front propeller shaft (3) to
Remove four capscrews (4), four lockwashers (5) and
disconnect rear propeller shaft (6). Discard lockwash-
Tag and disconnect lead (7) from transmission temper-
ature switch (8).