 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
FLYWHEEL HOUSING AND COVER MAINTENANCE - CONTINUED
0215 00
INSTALLATION
1.
Drive two ring dowels (7) into cylinder block until
they are against bottom of bore.
2.
Clean and dry rear crankshaft sealing surface.
7
7
409-973
NOTE
INSTALLATION/ALIGNMENT TOOL
Ensure oil seal sealing surface on the
B
crankshaft is clean to help prevent seal
leaks.
3.
Install new gasket (6) and rear cover (5) onto cylinder
5
block.
4.
Loosely install six capscrews (4).
5.
Place installation and alignment tool supplied with oil
seal kit over the crankshaft (B) and into the rear cover
(5). This aligns the cover to the crankshaft.
6.
Align rear cover (5) with both sides of the cylinder
4
6
409-974
block oil pan rail until surfaces are flush. Torque six
capscrews (4) to 7 lb-ft (10 Nm).
7.
Remove installation and alignment tool and trim gasket evenly with oil pan mounting surface at points "A".
A
409-975
0215 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals