ENGINE ASSEMBLY REPLACEMENT (165 HP) - CONTINUED
INSTALLATION - CONTINUED
Position coupling (8) with shaft assembly (4) into
engine dampener (10).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are harmful to
skin and clothing. Use protective gloves and goggles. To avoid injury or death, keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash
immediately with soap and water.
Apply sealing compound to threads of three screws (7).
Install coupling (8) on engine with three screws (7). Torque screws to 25 lb-ft (34 Nm).
Apply sealing compound to threads of four screws (1).
Install universal joint (3) of shaft assembly (4) on input yoke (5) of transmission (6) with four new lockwashers (2) and
screws (1). Torque screws to 41 lb-ft (56 Nm).
Install tie down straps to hoses and electrical wires as noted during engine removal and as necessary to prevent damage
to hoses and wires.
Install muffler (WP 0051 00).
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Using lifting device hoist and sling, position frame cross member (97) on frame (99).
Install fan (WP 0059 00).
Install radiator and service cooling system (WP 0053 00).
Service engine with engine oil (WP 0012 00).
Connect battery cable (WP 0107 00).
Adjust accelerator cable (WP 0049 00).
Run engine, check for leaks and proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE