 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
ALTERNATOR AND ALTERNATOR PULLEY REPLACEMENT (165 HP) - CONTINUED
0063 00
REMOVAL - CONTINUED
8.
Remove nut (24), washer (25), alternator pulley (14)
26
and fan (26) from alternator (4).
4
14
25
24
409-1857
INSTALLATION
1.
Install fan (26) and alternator pulley (14) on shaft of alternator (4) with washer (25) and nut (24). Torque nut to 75 lb-ft
(102 Nm).
2.
Install alternator brace (17) on engine (22) with screw (23). Do not tighten.
3.
Install alternator support (20) on engine (22) with three screws (21). Torque screws to 18 lb-ft (24 Nm).
4.
Align upper mounting holes of alternator (4) with alternator support (20) and install screw (18) and nut (19). Do not
tighten.
5.
Align lower mounting hole of alternator (4) with alternator brace (17) and install two new starwashers (16) and screw
(15). Torque screw to 60-70 lb-ft (81-95 Nm).
6.
Torque screw (23) to 32 lb-ft (43 Nm).
7.
Torque nut (19) to 57 lb-ft (77 Nm).
NOTE
Ensure drive belt is properly positioned around engine pulleys as noted during removal. If necessary, refer to
8.
Lift tensioner (12) and install drive belt (13) on alternator pulley (14).
0063 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals