TM10-3930-660-20 18-25. BOOM HYDRAULIC HOSE AND ELECTRICAL CABLE TENSION - ADJUST (cont‘d) 5. 6. h. i. j. k. l. m. Tighten capscrews (13) on set of clamp halves (14) closest to hose-tension plate (7). Check for proper routing of boom hydraulic hoses (4) and boom electrical cable (5) around pulley assembly (10) and hose tension plate (7). Check that length of hose tension springs (9) at hose tension plate (7) is 2-1/4 to 2-1/2 inches long. If necessary, readjust hose tension bolts (8) as required. Tighten two jamnuts (6) at hose tension plate (7). Pull boom electrical cable (2) rearward at set of clamp halves (14) farthest from hose tension plate (7) until cable (5) is snug. Secure boom electrical cable (5) to underside of boom by tightening capscrews (13) on remaining three sets of clamp halves (14). APPLY LOCTITE 242 TO FOUR BOLTS (1). POSITION BOOM COVER (3) ON REAR OF BOOM AND SECURE WITH FOUR NEW LOCKWASHERS (2) AND FOUR BOLTS (1). RETRACT BOOM, TM10-3930-660-10. 18-99