TM10-3930-660-20 18-14. FRAME  TILT  CYLINDER  -  REPLACE  (Cont’d) 6. REMOVE CYLINDER  (4)  FROM  VEHICLE. a. b. c. 7. IF Remove retaining ring (7). Using an assistant, support cylinder and remove rod pivot pin (8). Remove frame tilt cylinder (4) from vehicle. NECESSARY, REMOVE FOUR CAPSCREWS (9), FOUR LOCKWASHERS (10), AND TWO BRACKETS (11) FROM AXLE. INSTALLATION 1. IF REMOVED, SECURE TWO BRACKETS (11) TO AXLE WITH FOUR NEW LOCKWASHERS (10) AND FOUR CAPSCREWS (9). Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on cylinder and hoses clean and dry. 2. ATTACH CYLINDER (4) TO VEHICLE. a.   Position frame tilt cylinder (4) on vehicle so holes for rod pivot pin line up. Apply anti-seize compound to rod pivot pin (8) as installed. b. Install rod pivot pin (8). c. Install retaining ring (7) on rod pivot pin (8). 3. CONNECT HYDRAULIC HOSES (5). Connect two hydraulic hoses (5) to frame tilt cylinder (4) as tagged. 4. ALIGN AND CONNECT BASE PIVOT PIN (3). a. Start engine, TM10-3930-660-10. 18-56