TM10-3930-660-20 17-5. WINDSHIELD WASHER ASSEMBLY - SERVICE/REPLACE (Cont’d) INSTALLATION 1. IF REMOVED, POSITION HOSE (9) INSIDE SIDE CONSOLE (3). a. b. 2. IF Push hose (9) into side console (3) through hole at rear of side console  (3). Continue to push hose (9) through side console (3) until end of hose (9) appears inside front console (19) . REMOVED, INSTALL WASHER NOZZLE (15) TO CAB (16). a. b. c. 3. IF From outside vehicle, position washer nozzle (15) and new rubber washer (22) on cab (16). From inside dashboard, secure washer nozzle (15) with new starwasher (21) and nut (20). Push hose (9) onto washer nozzle (15) . Secure dashboard access panel (18) to front console (19) with four capscrews (17). REMOVED, INSTALL RESISTOR ASSEMBLY (5) TO SIDE CONSOLE (3). Apply Loctite 242 to screws (14) as installed. a. b. Position resistor assembly (5) on side console (3) and secure with two new locknuts (13) and two screws  (14). Connect female spade connector of electrical lead (12) to male spade connector on resistor assembly (5) as tagged. 17-13