TM10-3930-660-20 14-9. STEERING CYLINDER BALL JOINT END CAP ASSEMBLIES - REPLACE (Cont’d) INSTALLATION 1. INSTALL BALL JOINT END CAP ASSEMBLIES (1) AND (2) ON STEERING CYLINDER (3)0 a. b. c. d. e. f  . Install ball joint (2) on steering cylinder  (3).   Screw ball joint (2) onto steering cylinder (3) until it s tops l Tighten nut (7) and capscrew (8) on clamp  (9). Install ball joint (1) on steering cylinder  (3). Pull out rod of steering cylinder (3) until it is fully extended. Rotate ball joint (1) as required until distance between grease fittings on ball joints (1) and (2) is 26-3/8 in. Tighten nut (4) and capscrew (5) on clamp (6). 2. INSTALL STEERING CYLINDER, PARA.  14-8. 14-19