TM10-3930-660-20 14-7. STEERING HOSES, LINES AND FITTINGS ^- REPLACE Cont'd NOTE Note routing of hoses (2) use during installation. 3. CAREFULLY REMOVE HOSES on vehicle for (2) FROM VEHICLE FRAME AS REQUIRED. INSTALLATION NOTE Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hydraulic components and hoses clean and dry. Apply film of clean hydraulic oil to all seals as they are installed. NOTE The hydraulic lines must be mounted (indexed) in such a way to allow movement of the lines during steering without rubbing, crimping, or exceeding the minimum bend radius. 2. CAREFULLY POSITION HOSES (2) ON VEHICLE FRAME AS NOTED DURING REMOVAL  . INSTALL FITTINGS (1) AND HOSES (2) AT HYDRAULIC COMPONENTS (3). a. b. Install fittings (1) to hydraulic components  (3). Install hoses (2) to fittings (l). NOTE Install clamps (4) at locations noted during removal. 3. 4. INSTALL CLAMPS (4) AND MOUNTING HARDWARE (5) TO HOSES (2). USING AN ASSISTANT, OPERATE THE FORKLIFT THROUGH THE FULL STEERING RANGE; CHECKING TO ENSURE FREEDOM OF MOVEMENT OF ALL LINES AND FITTINGS. 14-13