TM10-3930-660-20 8-21. FORK AUTOLEVELER SWITCH -  REPLACE/ADJUST (Cont’d) Apply Loctite 242 to all capscrews and bolts as they are installed. 1. INSTALL FORK AUTOLEVELER SWITCH (1) AND CABLE TO CARRIAGE ASSEMBLY (3). a. b. c. d. e. f. g. Start  engine. Position carriage assembly (3) in a down position so that carriage tilt cylinders are fully extended. Stop engine. Position switch (1) on carriage assembly (3) and secure with four new lockwashers (33) and three capscrews  (32). Carefully position autoleveler cable (4) and grommet (30) through notch in switch cover (26). If removed, install conduit (31) to autoleveler cable (4). Position switch cover (26) on carriage assembly (3) and secure with two new lockwashers (29) , two capscrews (28) , two retainer nuts (27), two new lockwashers (25), and two  bolts  (24). If removed, install cable clamp (21)  to  autoleveler  cable  (4). Install, but do not tighten, capscrew (19)  and  new  lockwasher  (20). Slide conduit (31) on autoleveler cable (4) so it is positioned between cable clamp (21) and cable grommet  (30). Route autoleveler cable (4) through cable clamp (21) and pull cable (4) tight  from  top. Tighten  capscrew (19) and lockwasher (20) to secure cable clamp (21) and autoleveler cable (4) to clamp halves (22). 8-53