TM10-3930-660-20 8-21. FORK AUTOLEVELER SWITCH - REPLACE/ADJUST (Cont’d) d. e. f. g. Remove two bolts (24) and two lockwashers (25) from switch cover (26). Discard lockwashers (25). If necessary, remove two retainer nuts (27)  from  switch  cover  (26). Remove two capscrews (28) and two lockwashers (29) from switch cover (26). Remove switch cover (26) from carriage assembly (3). Discard lockwashers (29). Carefully remove autoleveler switch cable (4) and grommet (30) from notch in switch cover (26). If necessary, remove conduit (31) from autoleveler cable (4). Remove four capscrews (32) and four lockwashers (33) securing switch (1) to carriage assembly (3). Remove switch (1) from carriage assembly (3). INSTALLATION WARNING Failure to route autoleveler cable (4) as described, may result in damage to vehicle or its load due to malfunctioning of autoleveler system. Autoleveler cable (4) is part of autoleveler switch (1) and is non- repairable. If autoleveler cable (4) is damaged, entire autoleveler switch (1) must also be replaced. 8-52