TM10-3930-660-20 8-19. ELECTRIC JOYSTICK AND  HARNESS ASSEMBLY -  TEST/REPLACE (Cont'd) 2. IF REMOVED, SECURE JOYSTICK (2) TO COVER PLATE (1) . a. Position joystick (2) so that wide side of cover plate (1) is on same side as electrical terminals of joystick  (2). Apply Loctite 242 to threads of screws (l0) . b. Secure joystick (2) and gasket (19) to cover plate (1) with four new nylon washers (11) and four screws  (10). c. Install and tighten hose clamp (9) . 3. INSTALL COVER PLATE (1) AND JOYSTICK (2) AS AN ASSEMBLY TO THE SIDE CONSOLE  (3)0 a. Support joystick (2) and cover plate (1) as an assembly over side console  (3). b. Plug male plug (5) of joystick harness (6) into female plug (7) of vehicle wiring harness (8). c. Position cover plate (1) and joystick (2) as an side  console  (3). wide side of cover is  towards  driver. assembly into Make sure plate (1) Apply Loctite 242 to threads of capscrews  (4). d. Install four capscrews (4) to secure cover plate (1) to side console  (3). 4. CONNECT BATTERIES, PARA. 8-44. 8-43