TM  10-3930-660-20 5-22.    ACCELERATOR PEDAL ASSEMBLY - REPLACE/REPAIR (Cont‘d) INSTALLATION 1. POSITION ACCELERATOR PEDAL ASSEMBLY (4) ON CAB. Apply Loctite 242 to threads of capscrews (1) . Have an assistant retain capscrews (1) inside cab while nuts (2) are installed. 2. 3. 4. SECURE ACCELERATOR PEDAL ASSEMBLY (4) TO CAB WITH THREE CAPSCREWS (1) , THREE NEW LOCKWASHERS (3) , AND THREE NUTS (2) . CONNECT ACCELERATOR CABLE TO ACCELERATOR PEDAL (4), PARA. 5-21. CHECK ADJUSTMENT OF PEDAL CAPSCREW (32). a. b. c. d. Loosen jamnut (31) and turn capscrew (32) on accelerator pedal assembly (4) fully clockwise. Depress accelerator pedal to the end of its travel and hold. Turn capscrew (32) counterclockwise until head of capscrew (32) touches pedal. Release accelerator pedal and tighten jamnut (31). Use STE/ICE to check engine RPM at full throttle, para. 2-13. If necessary, readjust capscrew (32). as required, until engine full throttle RPM is within limits. . CONNECT ACCELERATOR CABLE AT PEDAL 5 ASSEMBLY (4), PARA. 5-21. 5-51/(5-52  Blank)