TM  10-3930-660-20 5-22. ACCELERATOR PEDAL ASSEMBLY - REPLACE/REPAIR (Cont’d) CLEANING  AND  INSPECTION Refer to Para. 3-4 for cleaning instructions and Para. 3-6 for inspection   instructions. ASSEMBLY ASSEMBLY  ACCELERATOR a. b. c. d. e. f. 9* h. i. j. Install jamnut PEDAL ASSEMBLY (4). (31)  and  capscrew (32) to pedal base (27). ^- Install bellows (30) to pedal base (27). Secure pedal (23) to pedal base (27) with pivot pin (29) and spring clip  (28). Install pushrod (12) to block assembly  (22). Secure block assembly (22) and pushrod (12) to pedal (23) with long pin (21) and two spring clips (20). Secure hanger plate assembly (9) to pedal base (27) with U-bolt (26), bracket (26A), new flatwasher (25) and nut (24). Install nyliner bearing (19), spring (18), lever assembly (13), nyliner bearing (17) and circlip (16) on shaft of hanger plate assembly (9). Secure travel stop (15) to lever assembly (13) with capscrew (14). Secure pushrod (12) to lever assembly (13) with short pin (10) and spring clip (11). Secure cable support bracket (8) to hanger plate assembly (9) with screw (5), flatwasher (6), and nut (7). 5-50