TM 10-3930-659-34 5-16.  REAR AXLE FRONT OSCILLATING SUPPI)RT YOKE, INPUT QUILL, AND PINION SHAFT MAINTENANCE. This Task Covers: a. Removal d.Assembly b. Disassembly e.Installation c. Cleaning and Inspection INITIAL SETUP: Equipment Conditions: Materials/Parts: • Rear axle assembly removed (see paragraph 4-48) Prussian blue dye (Item 24, Appendix B) • Lubricating oil (Item 38, Appendix B) Tools/Test Equipment: • Rags (Item 43, Appendix B) • General mechanic's tool kit (Item 71, Appendix E) • Dry cleaning solvent (Item 47, Appendix B) • Outside caliper micromer micromer (Item 9, Appendix E) • One cotter pin • Vise jaw caps (Item 12, Appendix E) • Two preformed packings • Dial indicator set (Item 19, Appendix E) • Three seals • Arbor press (Item 47, Appendix E) • Puller kit (Item 50, Appendix E) Personnel Required: Two • Machinist's vise (Item 76, Appendix E) Reference • Torque wrench, 0-600 lb.-ft (Item 82, Appendix E) • Axle yoke holding tool (Figure C-8, Appendix C) • TM 9-214 General Safety Instructions: • Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. • Prussian blue dye is poisonous, and can cause serious burr s and dizziness. Use only in a well-ventilated area. a.  REMOVAL 1 Remove six screws (1) and washers (2) from front input quill assembly (4) and differential housing (3). 5-152