TM 10-3930-659-34 5-15.  FRONT AXLE YOKE, INPUT QUILL, AND PINION SHAFT MAINTENANCE. This Task Covers: a. Removal d. Assembly b. Disassembly e. Installation c. Cleaning and Inspection INITIAL SETUP: Equipment Conditions: Materials/Parts: • Front axle assembly removed (see paragraph 4-47). • Prussian blue dye (Item 24, Appendix B) • Lubricating oil (Item 38, Appendix B) • Rags (Item 43, Appendix B) • General mechanic's tool kit (Item 71, Appendix E) • Dry cleaning solvent (Item 47, Appendix B) • Outside caliper micrometer (Item 9, Appendix E) • One cotter pin • Vise jaw caps (Item 12, Appendix E) • One seal • Dial indicator set (Item 19, Appendix E) • Two preformed packings • Arbor press (Item 47, Appendix E) • Machinist's vise (Item 76, Appendix E) Personnel Required:  Two • Torque wrench, 0-600 Ib.-ft.  (Item 82, Appendix E)   References: • Axle yoke holding tool (Figure C-8, Appendix C) • TM 9-214 General Safety Instructions: • Dry cleaning solvent is flammable and must not be used near  open flame.  Use only in a well-ventilated area. • Prussian blue dye is poisonous, and can cause serious burn, and dizziness.  Use only in a well-ventilated area. a.  REMOVAL 1    Remove six screws (1) and washers (2) from front input quill assembly (4) and differential housing (3). WARNING Use extreme caution when handling heavy parts. lifting device is required when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg) for a three or more person lift.  Keep clear of heavy parts supported only by lifting device.  Failure to follow tl is warning may cause serious injury or death to personnel. NOTE Front input quill assembly weighs approximately 70 lb (32 kg). 2    Remove front input quill assembly (4) from differential housing (3). 5-142