TM 10-3930-659-34 5-10.  TRANSMISSION OIL FEED FLANGE MAINTENANCE. This task covers: a. Removal d. Assembly b. Disassembly e Installation c Cleaning and Inspection INITIAL SETUP: Equipment Conditions: Materials/Parts: •· Transmission  input seal and  bearing removed • Sealing compound (Item 14, Appendix B) (see paragraph 4-43). • Lubricating oil (Item 38, Appendix B) Tools/Test Equipment: • Petrolatum (Item 42, Appendix B) • Rags (Item 43, Appendix B) • General mechanic's tool kit (Item 71, Appendix E)  • Dry cleaning solvent (Item 47, Appendix B) • Depth gage micrometer (Item 27, Appendix E) • Two gaskets • Heat gun (Item 35, Appendix E) • Retaining ring pliers (Item 46, Appendix E) References: • Arbor press (Item 47, Appendix E) • TM 9-214 • Mechanical puller (Item 51, Appendix E) • Torque wrench, 0-175 lb.-ft.  (Item 81, Appendix E) General Safety Instructions: • Air deflector plate (Figure C-6, Appendix C) • Dry cleaning solvent is flammable and must not be • Transmission oil supply flange removal brackets used near open flame.  Use only in a well-ventilated (Figure C-7, Appendix C) area. • Hot parts can cause severe burns.  Always wear protective clothing (goggles/shield, gloves, etc.). 5-79