| |
TM 10-3930-659-34
4-29. STARTER MOTOR REPAIR.
This Task Covers:
a.
Disassembly
c.
Assembly
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Starter motor removed (see TM 10-3930-659-20).
•
Adhesive (Item 1, Appendix B)
:
•
Crocus cloth (Item 8, Appendix B)
Tools/Test Equipment
•
Lubricating oil (Item 40, Appendix B)
•
General mechanic's tool kit (Item 71, Appendix E)
•
Rags (Item 43, Appendix B)
•
Compressor unit (Item 16, Appendix E)
•
Paint thinner (Item 54, Appendix B)
•
Armature test set (Item 64, Appendix E)
•
One gasket
•
Test stand, generator and starter (Item 65, Appen-
•
One locknut
dix E)
•
One ring
References:
One seal
•
Fourteen preformed packings
•
TM 10-3930-659-20
Personnel Required: Two
General Safety Instructions:
•
Paint thinner is flammable and must not be used near open flame.
•
Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).
a. DISASSEMBLY
1. Remove nut (1) and cover (2) from starter motor solenoid (3).
2. Remove two screws (5), strap (6), and grommet (7) from starter motor solenoid (3) and starter housing (4).
3. Mark starter motor solenoid (3) and housing (9) to aid during assembly.
4. Remove three screws (10), starter motor solenoid (3), and preformed packing (8) from housing (9). Discard
preformed packing.
4-112
|