TM 10-3930-659-34 4-14. ENGINE FRONT COVER REPLACEMENT (Con’t). 9. Remove   wear   sleeve   (22),   preformed   packing (21), and slinger (20) from crankshaft (23).  Dis- card preformed packing. b. INSTALLATION I 1. Install slinger (20), new preformed packing (21), and wear sleeve (22) on crankshaft (23). 2. Apply grease to springloaded lip of new front seal (18). 3. Apply  sealing  compound  to  outside  edge  of  new  front  seal  (18)  and  position  front  seal  in  engine  front  cover  (3) with springloaded lip facing rearward. CAUTION DO   NOT   pry   or   press   against   engine   front   cover   with   excessive   force   when installing front seal.  Engine front cover is made of aluminum and excessive force may cause damage. 4. Using crankshaft front oil seal driver and a hammer, install front seal (18) on engine front cover (3). 5. Install  new  gasket  (11),  access  cover  (12),  and  spring  retaining  bracket  (13)  on  engine  front  cover  (3)  with  two washers (14) and screws (15).  Torque screws to17 lb.-in.  (2 N•m). 6. If removed, install two studs (19) on engine block (9). 7. Install new gasket (10) and engine front cover (3) on two studs (19) with new lockwashers (16) and nuts (17). 8. Connect fuel injection lever spring to spring retaining bracket (13). TA708103 4-64