TM 10-3930-659-34 4-4. ENGINE MOUNTS REPLACEMENT. This Task Covers: a. Front Engine Mounts Replacement b. Rear Engine Mounts Replacement Initial Setup: Equipment Conditions: Tools/Test Equipment: • Engine hood removed (see TM 10-3930-659-20). • General mechanic's tool kit (Item 71, Appendix E) • Torque wrench, 0-600 lb.-ft.  (Item 82, Appendix E) Personnel Required:  Two References: • TM 10-3930-659-20 a. FRONT ENGINE MOUNTS REPLACEMENT NOTE Two front engine mounts are replaced the same way.  One front engine mount is illustrated. 1. Attach suitable lifting device to engine assembly (5).  Attach lifting sling to two engine lifting brackets (4) and raise lifting device enough to support weight of engine assembly. 2. Remove nut (8), washer (9), screw (3), and washer (2) from frame bracket (7). NOTE Take up slack on lifting device as necessary to remove engine mounting bracket and resilient mount. 3. Remove four screws (11), washers (10), engine mounting bracket (6), and resilient mount (1) from engine assembly (5) and frame bracket (7). 4. Position resilient mount (1) on engine mounting bracket (6) and install engine mounting bracket on engine assembly (5) with four washers (10) and screws (11).  Torque screws to 105 lb.-ft.  (142 N•m). 5. Install engine mounting bracket (6), washer (2), screw (3), washer (9), and nut (8) on frame bracket (7).  Torque nut to 270 lb.-ft.  (366 N•m). 6. Remove suitable lifting device and lifting sling from engine assembly (5). 4-10