TM 10-3930-659-20 17-19.    FORKLIFT CONTROL VALVE-TO-PLATE HOSES REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Parking brake set (see TM 10-3930-659-10). • Rags (Item 27, Appendix C) •    Frame locking bar Installed (see TM 10-3930- • Eighteen preformed packings •    Transmission side guards removed(see para-  References: graph 14-7). • TM 10-3930-659-10 •    Right side cab skirt removed (see paragraph 14-6). Tools/Test Equipment: •    General mechanic's tool kit (Item 44, Appendix F) NOTE • Six forklift control valve-to-plate hoses and fittings are removed and Installed the same way, except only two hoses have elbows.  One forklift control valve- to-plate hose and fittings Is Illustrated. •  A  suitable  container  should  be  used  to  catch  any  draining  hydraulic  fluid. Ensure that all spills are properly cleaned. a. REMOVAL 1. Remove hose (6) and preformed packing (5) from adapter (4).Discard preformed packing. 2. Remove adapter (4) and preformed packing (3) from forklift control valve (2).Discard preformed packing. 3. Remove hose (6) and preformed packing (7) from plate (1).Discard preformed packing. 4. Repeat steps 1 through 3 for other five hoses (6). b. INSTALLATION 1. Install new preformed packing (3) and adapter (4) on forklift control valve (2). 2. Install new preformed packing (7) and hose (6) on plate (1). 3. Install new preformed packing (5) and hose (6) on adapter (4) 4. Repeat steps 1 through 3 for other five hoses (6). 17-62