| |
TM 10-3930-659-20
17-9.
CARRIAGE TILT CYLINDER REPLACEMENT.
This Task Covers:
a. Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Parking brake set (see TM 10-3930-659-10).
•
Grease (Item 23, Appendix C)
•
Carriage assembly lowered to ground
(see TM 10-3930-659-10).
•
Locking control valve removed (see para-
References:
graph 17-10).
• TM 10-3930-659-10
Tools/Test Equipment:
•
General mechanic's tool kit (Item 44, Appendix F)
a.
REMOVAL
1.
Attach suitable lifting device to carriage tilt cylinder (3) and raise lifting device enough to support weight of
carriage tilt cylinder.
2.
Remove screw (9), washer (8), spacer (7), and pin (6) from carriage assembly (5).
3.
Remove screw (12), washer (11), spacer (10), and pin (1) from loader frame (2).
WARNING
Use extreme caution when handling heavy parts. Lifting device Is
required when parts weigh over 50 lb (23 kg) for a single person
lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg)
for a three or more person lift. Keep clear of heavy parts supported
only by lifting device. Failure to follow this warning may cause
serious Injury or death to personnel.
NOTE
Quantity of spacers may vary. Note number and position of spacers to aid during Installation.
4.
Remove carriage tilt cylinder (3) and spacers (4) from loader frame (2) and carriage assembly (5).
5.
Remove suitable lifting device from carriage tilt cylinder (3).
17-30
|