TM 10-3930-659-20 7-9. TRANSMISSION CLUTCH CUTOFF CONTROL ASSEMBLY MAINTENANCE. This task covers: a. Removal c. Adjustment b. Installation INITIAL SETUP: Equipment Conditions: Materials/Parts: • Parking brake set (see TM 10-3930-659-10). • Marker tags (Item 33, Appendix C) • Battery disconnect switch in OFF position (see • Two locknuts TM 10-3930-659-10). • Battery cables disconnected (see paragraph 6-43) References: Tools/Test Equipment: • TM 10-3930-659-10 • General mechanic's tool kit (Item 44, Appendix F) a. REMOVAL NOTE All wires should be tagged before removal.  Refer to paragraph 2-18 for tagging Instructions. 1. Remove two screws (5), under cab wiring harness leads (4 and 6), and suppressor wires (7) from clutch cutoff microswitch (8). 2. Remove nut (14), washer (13), screw (12), and assembled transmission clutch cutoff control assembly. 3. Remove two locknuts (9), clutch cutoff microswitch (8), two washers (3), and screws (15).  Discard locknuts. 4. Remove spring (10) from lever (11) and bracket (2). 5. Remove screw (1) and lever (11) from bracket (2). b. INSTALLATION 1. Install lever (11) on bracket (2) with screw (1). 2. Install spring (10) on lever (11) and bracket (2). 3. Install two washers (3) and clutch cutoff microswitch (8) on bracket (2) with two screws (15) and new locknuts 4. Install assembled transmission clutch cutoff control assembly with screw (12), washer (13), and nut (14). 5. Position tip of lever (11) under edge of left brake pedal. 7-24