| |
TM 10-3930-659-20
2-28.
ELECTRICAL REPAIR (Con't).
g.
Wiring Harness Receptacle Repair.
NOTE
Male and female Inserts are replaced the same way. Male Insert is Illustrated.
(1)
Open connector body (18).
(2)
Remove wire lead (16) from connector body (
(3)
Cut insert (17) off wire lead (16) and discard.
(4)
Remove insulation from wire lead (16)
equal to depth of new insert (17).
(5)
Position new insert (17) on wire lead
(16) and crimp (Item 43, Appendix F).
(6)
Press insert (17) into connector body
(18) until fully seated.
(7)
Pull on wire lead (16) slightly to ensure
that insert (17) is locked in place.
(8)
Close connector body (18).
h.
Plug Assembly Repair.
NOTE
Male and female Inserts are replaced the same way. Female Insert Is Illustrated.
(1)
Remove wire lead (19) from plug (21).
(2)
Cut insert (20) off wire lead (19) and
discard.
(3)
Remove insulation from wire lead (19)
equal to depth of new insert (20).
(4)
Position new insert (20) on wire lead
(19) and crimp (Item 43, Appendix F).
(5)
Press wire lead (19) into plug (21) until
fully seated.
(6)
Pull on wire lead (19) slightly to ensure
that insert (20) is locked In place.
TA706728
2-23
|
