TM 10-3930-659-20 6-22. FRONT TURN SIGNAL/EMERGENCY FLASHERS AND FRONT BLACKOUT LIGHT MAINTENANCE (Con't). 2. If damaged, remove preformed packing (6) and discard. 3. Remove  two  lamps  (1)  from  two  sockets  (2)  and  lamp  (5)  from  socket  (3)  by  pushing  lamps  in  and  turning counterclockwise. 4. Install two lamps (1) in two sockets (2) and lamp (5) in socket (3) by pushing lamps in and turning clockwise. 5. If removed, install new preformed packing (6) on door (8). 6. Install door (8) on housing (4) and tighten five screws (7). b. REMOVAL NOTE • All wires and connectors should be tagged before removal.  Refer to paragraph 2-18 for tagging Instructions. • Left  and  right  front  turn  signal/emergency  flashers  and  front  blackout  lights  are removed and Installed the same way.  Left front light is illustrated. • One wire of housing is not used. 1. Disconnect two connectors (11) from connectors (12). 2. Remove screw (14), washer (13), clamp (15), and two loader frame wiring harness wires (10) from bracket (19). TA707791 6-105