TM 10-3930-659-20 6-11. INSTRUMENT   PANEL   LIGHT   SWITCH,   BLACKOUT   LIGHTS   SWITCH,   REAR   WORKLIGHT   SWITCH, CLUTCH  CUTOFF  SWITCH,  DRIVING  LIGHTS  SWITCH,  ADJUSTABLE  FLOODLIGHT  SWITCH,  AND  AIR COMPRESSOR SWITCH REPLACEMENT. This Task Covers: a.   Removal b. Installation Initial Setup: Equipment Conditions: Materials/Parts: • Battery disconnect switch In OFF position (see •  Marker tags (Item 33, Appendix C) TM 10-3930-659-10). • Right access door opened (see TM 10-3930-659-10). References: • Cab window opened (see TM 10-3930-659-10) •  TM 103930-659-10 Tools/Test Equipment: • General mechanic's tool kit (Item 44, Appendix F) NOTE • Instrument  panel  light  switch,  blackout  lights  switch,  rear  worklight  switch,  clutch cutoff switch, driving lights switch, adjustable floodlight switch, and air compressor switch  are  removed  and  Installed  the  same  way  except  quantity  of  wires  may  vary. Clutch cutoff switch Is Illustrated. • All terminal leads should be tagged before removal.  Refer to paragraph 2-18 for tagging Instructions. a. REMOVAL 1. Remove two screws (6) and terminal leads (5) from clutch cutoff switch (4). NOTE Note position of clutch cutoff switch to aid during installation. 2. Remove nut (1), lockring (2), and clutch cutoff switch (4) from right panel cover (3). b. INSTALLATION 1. Install clutch cutoff switch (4) on right panel cover (3) with lockring (2) and nut (1). 2. Install two terminal leads (5) on clutch cutoff switch (4) with two screws (6). 6-34