TM 10-3930-659-20 6-10. IGNITION SWITCH REPLACEMENT This Task Covers: a.   Removal b. Installation Initial Setup: Equipment Conditions: Materials/Parts: • Battery disconnect switch in OFF position (see •  Marker tags (Item 33, Appendix C) TM 10-3930-659-10). • Right access door opened (see TM 10-3930-659-10). References: • Cab window opened (see TM 10-3930-659-10) •   TM 10-3930-659-10 Tools/Test Equipment: • General mechanic's tool kit (Item 44, Appendix F) a. REMOVAL NOTE All  wires  and  connectors  should  be  tagged  before  removal.    Refer  to  paragraph  2-18  for tagging Instructions. 1. Remove right panel wiring harness wire (3) from ground connector (7). 2. Disconnect two right panel wiring harness connectors (4 and 5) from Ignition switch (6). 3. Remove nut (2) and ignition switch (6) from right panel cover (1). 4. Remove ground connector (7) from ignition switch (6). b. INSTALLATIONI 1. Position ground connector (7) on ignition switch (6). 2. Install ignition switch (6) on right panel cover (1) with nut (2). 3. Connect two right panel wiring harness connectors (4 and 5) to ignition switch (6). 4. Install right panel wiring harness wire (3) on ground connector (7). 6-32