TM 10-3930-659-20 5-26. FUEL INJECTION PUMP STATIC TIMING ADJUSTMENT. (Con't). 3. Install flywheel turning tool (5) on engine (1). 4. Turn flywheel turning tool (5) clockwise until tim- ing pin (6) can be Installed on engine (1) and en- gages flywheel. 5. Remove two screws (11), cover (10), and gasket (9) from fuel injection pump (12).  Discard gasket. (a) If timing mark (7) is visible, No.1 piston is at top dead center TDC) on the compression stroke.  Skip step 7 and perform step 8. 6. Note timing marks (7 and 8). (b)    If timing mark (7) is not visible, perform step 7. Remove  timing  pin  (6)  and,  using  flywheel turning tool (5), rotate flywheel one complete turn  to  place  No.    1  piston  at  TDC.    Install timing pin. TA706900 5-76