TM 10-3930-653-14&P FORK STOPPER Fork stoppers are to lock the forks In position.  To  adjust fork spacing, pull up  fork stoppers,  turn,   and  shift  the forks to the desired positions The fork spacing should be adjusted according to loads to be handled. CAUTION The    forks    should    be    set    symmetrically    to    machine centerline  and  fork stoppers should always be set. RADIATOR CAP The radiator cap is located at  the  rear  part  of  the  hood. To remove the cap, turn it left 90°. WARNING Do not remove the radiator cap abruptly while the engine is  hot  Turn  the  cap  a  little  to  the  left  to  relieve  the pressure        In    the    radiator,    then    remove    the    cap. LIGHTS & LAMPS HEAD LIGHT A head light is installed on the front of the truck.  Take care of the light and wipe off dirt, if any, and replace any damaged light immediately. REAR LAMP This combination stop and tail lamp provides warning to other drivers that you are braking. FUEL RESERVOIR CAP(GASOLINE) The fuel  reservoir  cap  is  located  at  the  rear  left  side  of the truck body To open release latch and lift cap against sprinq tension WARNING -FUEL HANDLING- ·  Stop  the  truck,  shut  down    the  engine  and  apply  the parking  brake  securely.    Make  sure  that  there  is  no naked flame near the area.  Never smoke.  The driver should not remain seated when adding fuel. ·    After  addition  of  fuel  is  finished,  securely  close  the reservoir cap.  A loose cap could cause a fuel leak or fire hazard. ·  Before  attempting  to  start  the engine, make certain that no fuel is spilt on or around the truck. 2-8