TM 10-3930-653-14&P HOUR METER [1] This meter measures working time of engine.  Use meter to schedule lubrication and maintenance periods. WARNING LAMPS [21] These    warning    lamps    indicate    whether    or    not    their corresponding  devices  are  working  properly  Each  lamp lights up when an abnormal condition takes place in the corresponding device. CAUTION If   the   light   continues   to   stay   lit   or   lights   up   during operation,    the    charging    rate    is    low    and    should    be checked immediately. CHG (A) This  lamp  indicates  the  battery  condition  of  charge  The lamp comes on when the  ignition switch is set at "ON"*, but it goes out as the engine starts and accelerator pedal is pressed. CAUTION If   this   light   continues   to   stay   lit   or   lights   up   during operation,   the   pressure   is   insufficient   and   should   be checked Immediately. OIL (B) This lamp indicates the pressure condition of engine lube oil.  Although it lights up when the engine switch is set at "ON"  ,  once  the  engine  starts  up  and  the  accelerator pedal is depressed, this lamp goes out AMMETER [3] - This indicates the battery state of charge.  During engine running, the pointer should indicate plus (+) side. CHOKE BUTTON [4] When  starting  a  cold  engine,  first  pull  out  this    choke button    and    turn    the    key  switch.    After  the  engine  Is started up, do not fall to return the choke button into the original  position,  otherwise,  engine  trouble  or  increased fuel consumption will occur FUEL GAUGE [5] When  ignition  switch  is  set  to  the  position  "ON"*,  the gauge  informs  operator  how  much  fuel  remains  in  the fuel tank "E" mark stands for "Empty", "F" "Full". 2-2