ADJUSTING CARRIAGE ROLLERS - continued - TM-10-3930-647-14-P0377

After both thrust rollers have been adjusted, their grease

fitting should be lubricated.

This completes the procedure for adjusting the six-roller

carriage used on the triple stage upright. If upright

rails are also going to be adjusted, the carriage would

not be re-installed at this time, Upright adjustment pro-

cedure is given in Section 11, of this Manual. Whether

installed at this point or after rail adjustment, here's

how it's done.

INSTALLING THE CARRIAGE

Drive the truck up to the carriage.

Move the truck up slowly and raise the lift cylinder

to position the carriage rollers directly below the inner

rails and lower the lift cylinder completely. Turn off

the truck, set the parking brake, and block the steer tires.

Untie the carriage chains.

5-147