 |
|||
|
|
|||
|
Page Title:
REASSEMBLY OF CONTROL COVER - continued |
|
||
| ||||||||||
|
|
 Step 1 Plate 8072.
S t e p 3 Plate 8071.
Exercise catuion to avoid damaging the
I n s t a l l inching valve and components shown
lip of the oil seal during installation
above. Replace roll pin.
of the selector spool. Place a new "0"
ring on the stop and push it into the
housing.
Plate 8070.
Step 4
Exercise caution to avoid damaging the
lip of the oil seal during installation
of the high & low selector spool. Place
a new "0" ring on the stop and push it
into the housing. Install the retaining
roll pin.
S t e p 2 Plate 8073.
Start a roll pin in the housing. Push
down stop with a punch and tap roll pin
in to retain the stop. This procedure
will be repeated at each roll pin after
the necessary components are installed in
their bores.
5-80AQ
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals