| |
TM 10-3930-643-34
GENERAL SUPPORT PROPELLER AND PROPELLER SHAFTS MAINTENANCE.
16-2.
Front and Rear Planetary. (Sheet 4 of 4)
ASSEMBLY
11.
12.
13.
14.
15.
15.
16.
17.
18.
19.
Using a 1-1/2” socket and torque
wrench, install two bolts (16) to
planetary carrier (17).
Tighten
bolts (16) to 24 to 26 lb-ft torque.
NOTE
The following steps are for the
assembly of one gear
assembly.
Assembly of the remaining two
gear assemblies is identical.
Using snap
ring pliers, install
retaining ring (15), spacer (14) and
cups (13 and 12) to gears (6).
cup
(13 and 12) must be chilled until
cups can drop into gears (6) without
a press.
Install cone (11), spacer (10) and
cone (9).
Install items 15 thru 8 as an
assembly and three spacers (7) in
planetary carrier.
Install three spacers (6) on pins
(4) making sure tapered side of
spacer (7) is flush with tapered
portion of pin (4)
Using a hammer, install three pins
(4) with spacers (6) and dowels (5)
into planetary carrier.
Flat of
pins (4) must be toward outside of
planetary carrier.
Install three lock bolts (3). Tighten
bolts (3) to 110 to 120 lb-ft torque.
Using long round nose pliers, install
new lockwire (2) on vehicles S/N 2001
and above only.
Install new lockwire (1).
Peen the planetary housing at dowel
hole to secure dowel (5) in housing.
END OF TASK
16-18
|
